ELECTRICAL SAFETY

ELECTRICAL SAFETY

ELECTRICAL INSPECTION THE FOLLOWING EXAMPLES ARE INTENDED TO ASSIST THE BUILDING MANGER IN DETERMINING THE DEGREE OF COMPLIANCE, WTHIN HIS/HER OPERATIONS AND ACTIVITIES AND THE ASSOCIATED ELECTRICAL HAZARDS IN THEIR BUILDINGS. ALL DESIGN AND INSTALLATION OF EQUIPMENT AND FACILITES SHALL BE IN ACCORDANCE WITH APPLICABLE NEC, OSHA, DOE, AND SLAC POLICIES AND PROCEDURES.

INSPECT WORK AREA FOR ELECTRICAL HAZARDS DAILY, SHOULD INCLUDE, BUT NOT LIMITED TO THE FOLLOWING: EXTENSION CORDS FRAYED OR WORN

GROUND PIN INPLACE (MISSING) CONTINUOUS LENGTHS; NO DAISY-CHAINING

ACCEPTABLE

UNACCEPTABLE

PROTECT FROM DAMAGE INCLUDING THAT CAUSED BY FOOT OR VEHICLE TRAFFIC

ELECTRICAL PANELS “NO OBSTRUTION WITHIN 36 INCHES” IS THERE SUFFICIENT CLEARANCE AROUND ELECTRICAL EQUIPMENT?

GFCI (GROUND FAULT CIRCUIT INTERRUPTER) WITHIN SIX FEET OF SINKS AND EXTERIOR DOORS; ON METAL-SURFACED WORKBENCHES; ON OUTDOOR RECEPTACLES

OUTDOOR WEATHERPROOF COVER (MISSING)

TEST MONTHLY IF PRACTICAL

PROTECTIVE COVERS GUARDING OF ENERGIZED PARTS TO PREVENT ACCIDENTAL CONTACT; OVER POWER PANELS, JUNCTION BOXES, AND UNUSED HOLES.

ELECTRICAL PANEL DIRECTORIES IN PLACE AND ACCURATE AND POWER CABINETS AND BREAKERS PROPERLY LABELED

ENERGIZED WORK ALERT THE OCCUPANTS OF THE PLANNED WORK WARNING SIGNS AND BARRICADES PPE (PERSONAL PROTECTIVE EQUIPMENT)

LOCKOUT & TAGOUT DEVICE ATTACHED TO PREVENT OPERATION

OTHER HAZARDS/VIOLATIONS RACEWAY CANNOT BE USED TO SUPPORT LOW VOLTAGE OR LIMITED ENERGY CABLES GROUNDING & BONDING OF CABLE TRAYS

OVERLOADED POWER STRIP METAL LADDER IN AREA WHERE EXPOSED ENERGIZED PARTS ARE PRESENT

MAINTENANCE & REPAIRS UNQUALIFIED PERSONS SHALL NOT TAMPER WITH BUILDING ELECTRICAL WIRING

ELECTRICAL SAFETY IS EVERYONE’S RESPONSIBILITY ! REDUCING & ELIMINATING EXPOSURE TO ELECTRICAL HAZARDS REQUIRES YOUR CONSTANT ATTENTION